Automatic edge banding machine common faults and maintenance

    Automatic edge banding machine is a kind of manual edge sealing procedure: conveying - glued edge - cutting - front and rear head - up and down trimming - up and down finishing edge - up and down scraping - polishing Highly automated machine, this machine is suitable for straight edge sealing of solid wood board, fiberboard, particle board, MDF board, etc. The material can be solid wood strip, PVC, melamine, thin veneer, etc. The automatic edge banding machine is mainly used in the necessary equipment for panel furniture such as wardrobe factory, cabinet factory and office furniture factory.

    Common edge banding machine common faults and maintenance:

    1：gas path failure:

    The valve of the automatic edge banding machine is out of order, leaking gas, low air pressure, cutting knife, feeding and not working, etc., mainly checking the integrity of various pneumatic components.

    2：maintenance methods:

    It is ok to replace the parts, usually prepare more in case.

    2bonding failure:

    can not stick, run off, entrainment, etc. This is a comprehensive fault, related to the rubber shaft, edge band, sol, substrate and operation.

    maintenance methods:

    In the automatic edge banding machine, such failure may occur alternately or in a single occurrence. The specific maintenance depends on the situation.

    3：Electrical failure:

    including the host stop, the temperature is not fast, the program is disordered, etc., will not be eliminated in time, will burn the motor and heating tube or even damage the entire mechanical system.

    maintenance methods:

    Check the electrical control box, motor, heating tube, delay device, etc. of the automatic edge banding machine. This type of overhaul is usually repaired by a professional or by a manufacturer's manufacturer.

    4：Mechanical failure:

    transmission failure, uneven glue, feeding failure and cutter failure.

    maintenance methods:

    Check the integrity and firm parts of the various parts of the automatic edge banding machine, and whether the transmission parts are offset.