Hydraulic clamp industry has outstanding advantages

      Hydraulic clamp industry has outstanding advantages
      Hydraulic clamp industry uses the air pressure to drive the pump. When the outlet oil pressure reaches the set pressure， it stops the operation and does not need to continue to consume energy. If the outlet pressure drops， the pressure is automatically supplemented， and the pressure function is continuously maintained.
     The outlet pressure of the hydraulic clamp industry is proportional to the air pressure of the drive. Therefore， the outlet pressure also changes with the adjustment of the air pressure. It can be used with different output， different flow pumps and different types of loop control systems.
     When clamping the workpiece blank， the contour size often differs. After the workpiece reference is determined， if the irregular contour is supported by the fixed spacer， when the contour size is too small， the spacer will not be able to contact the workpiece， and if the contour size is too large， the contact is too early. When pressed or machined， the workpiece will be deformed. With the auxiliary support cylinder， before the hydraulic power is applied， the piston of the cylinder can be stopped at any point and surface of the blank contour under the action of the internal spring to ensure contact with the workpiece and to conform to the contour.
    After the hydraulic clamp industry is applied， the position of the piston is locked. The locked auxiliary support cylinder acts as a fixed block for the workpiece， and provides a reaction force to any pressing force or cutting force in the opposite direction of the piston movement. Additional support points are provided in the case of point plane positioning. After the Hydraulic clamp industry frame is processed， the oil pressure is released， the workpiece is taken away， and the piston automatically returns to the full height.
    Contour sizes often vary when holding workpiece blanks. After the workpiece reference is determined， if the irregular contour is supported by the fixed spacer， when the contour size is too small， the spacer will not be able to contact the workpiece， and if the contour size is too large， the contact will be too early， and the workpiece will be deformed when pressed or processed. The Hydraulic clamp industry utilizes an auxiliary support cylinder. Before the hydraulic power is applied， the piston of the cylinder can be stopped at any point and surface of the blank contour under the action of the internal spring to ensure contact with the workpiece and to conform to the contour.