Repair and maintenance of portable edge banding machine
Portable edge banding machine is a curved double-sided adhesive woodworking edge banding machine. Based on the advantages of manual edge banding machines at home and abroad, combined with the experience of manufacturing woodworking machinery for many years, the manual edge banding machine is not only easy to operate, but also easy to operate. And the structure is reasonable.
The portable edge banding machine is suitable for the edge-sealing operation of various shapes of furniture. It is widely used in small and medium-sized furniture factories. It has the characteristics of convenient operation and easy maintenance. The sealing operation range is large, which can ensure that the hot-melt adhesive is not sticky and suitable for various kinds. The straight curved edge of the sheet is small in size and light in weight. Small edge banding machine for woodworking is used for furniture processing, cabinet processing, interior decoration board edge sealing, etc. It is inexpensive and widely used.
The portable edge banding machine adopts foreign advanced technology, double-sided glue coating system, and the structure is advanced under-type plastic box. This structure is glued with rubber shaft and glued evenly. It can choose double-sided glue on plate and sealing tape and feed by hand. Evenly coated with medium-temperature adhesive on the edge strip and the board is more firm. After cooling, it can not be torn off, and the side curve and straight edge of the board can be sealed. Promise electronic speed regulation, smooth speed regulation, can be adjusted according to actual needs, sealing off the board, you can use the foot switch to instantly control the transmission belt control.
Failure of the portable edge banding machine:
1. Electrical failure. Including the host stop, the temperature is not fast, the program is disordered, etc., if not eliminated in time, it will burn the motor and the heating tube, and even damage the entire mechanical system. Mainly check the electrical control box, motor, heating tube, etc. during maintenance. This type of overhaul is usually repaired by a professional or by a manufacturer's manufacturer.
2, failure. Including gas valve failure, air leakage, low air pressure, cutting knife, feeding does not work, etc., mainly check the integrity of various pneumatic components of portable edge banding machine, replacement parts can be carried out under the guidance of the manufacturer's technical staff.
3. Mechanical failure. There are mainly transmission failures, uneven glue coating, feeding failure and cutter failure. It mainly checks the integrity and firm parts of the portable edge banding machine, and whether the transmission parts are offset.
4, bonding failure. Such as sticking, deviation, entrainment, etc., this is a comprehensive fault, related to the rubber shaft, edge band, sol, substrate and operation. Such failures may occur alternately or in a single occurrence, depending on the situation.
How to maintain the portable edge banding machine:
1. Maintenance and maintenance is an ecological edge banding machine that must perform a job every day.
2. Before the equipment is turned on, be sure to carefully check whether the parts are firm and tighten if loose.
3. After use, it is necessary to clean the dust and impurities on the machine in time, especially the rubber pot, so as not to affect the edge sealing effect of the later plates.
4. To ensure the normal operation of the lubrication system, it is necessary to periodically replace the lubricating oil to lubricate the relevant parts. The choice of lubricant should be suitable for the nature of the machine, and the wrong use will have a certain impact on the operation of the machine.
5, long-term use, cut off the power supply, put it in a safe place.